Kaman ThreadChecker Manuel d'utilisateur télécharger pdf (Page 5)

PART NO: 860510-001A Kaman Precision Products

Last Revised: 6/8/11 Measuring & Memory Systems

217 Smith Street

Middletown, CT 06457

www.kamansensors.com or 860-632-4442

Page 5 of 13

Operation of the ThreadChecker

Wire colors & pin-out.

The wire colors and typical connection diagram are as follows.

Teach sequence

Before the system is first used it must have the ‘teach’ sequence run. In order to do

this you must have a representative threaded and non-threaded hole. The system can

be easily calibrated to any new sensor designed for the ThreadChecker as well as for

most hole/thread configurations with a simple calibration sequence.

1. Connect the sensor and power source to the electronics. Allow the system to

warm up for a minimum of 5 minutes.

2. With the sensor in ‘air’ (i.e. not in a hole or near any conductive material), press

and hold the ‘Teach’ button until the Thread LED blinks fast then release (more

than 1 second but less than 10 seconds), the Thread LED should blink slowly.

3. Position the sensor tip in the threaded hole and momentarily press the ‘Teach’

button. The Status LED will blink fast.

4. Position the sensor in an unthreaded or bad hole and momentarily press the

‘Teach’ button. The LED should be solid red indicating no threads present. The

system is now calibrated and ready for use.

Since the switch point is half way between these 2 points you can teach these in

reverse order (bad then good) if desired.

1 2 3 4 5 6 7 8 9 10 11 12 13

Pas de commentaire

Kaman ThreadChecker Manuel d'utilisateur Page 5